Code Search

Please fill the "Code Box" to find engine fault code.

Car Models :

Please select your car.

How To Clear Check Engine Lights ?

Ways to clear check engine light on car panel.

Check Engine Light Dictionary

Ways to clear check engine light on car panel.

P2734 Engine Trouble Code

Meaning of P2734 engine trouble code is a kind of powertrain trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

P2734 Fault Symptoms :

Check engine light comes on
Engine stalling or misfiring
Engine performance issues
Car not starting

If one of these reasons for P2734 code is occuring now you should check P2734 repair processes.
Now don't ask yourself; What should you do with P2734 code ?
The solution is here :

P2734 Possible Solution:

Power Steering Pressure (PSP) Switch Malfunction In Key On, Engine Off Self-Test, this DTC indicates the PSP input to the PCM is high. In Key On, Engine Running Self-Test, this DTC indicates that the PSP input did not change state. Steering wheel must be turned during Key On, Engine Running Self-Test PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged.

P2734 Code Meaning :

P	2	7	3	4
OBD-II Diagnostic Powertrain (P) Trouble Code For Engine	Fuel And Air Metering (Injector Circuit Malfunctions Only)	Fuel Rail Pressure Sensor Circuit Malfunction	Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)	Timing Reference High Resolution Signal A Too Many Pulses

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

P2734 OBD-II Diagnostic Powertrain (P) Trouble Code Description

P2734 engine trouble code is about Timing Reference High Resolution Signal A Too Many Pulses.

Main reason For P2734 Code

The reason of P2734 OBD-II Engine Trouble Code is Fuel Rail Pressure Sensor Circuit Malfunction.

P2734 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.

	Example: 0140